Static IP on Loopback Interface

TL;DR

Assigning a static IP address to your loopback interface (other than the default 127.0.0.1) is possible, but generally not needed for standard operation. This guide shows how to do it on Linux systems using systemd-networkd and NetworkManager. It’s useful in specific testing or development scenarios.

Setting a Static IP on Loopback

The loopback interface (usually lo) is used for internal communication within your computer. By default, it’s assigned the address 127.0.0.1. Changing this isn’t typical, but can be useful in certain situations.

Method 1: Using systemd-networkd

1. Create a network file for the loopback interface: Create a new configuration file in /etc/systemd/network/. Name it something descriptive, like loopback.netdev.

   sudo nano /etc/systemd/network/loopback.netdev

2. Configure the interface: Add the following content to the file, replacing 192.168.50.100/32 with your desired static IP address and subnet mask.

   [NetDev]
   Name=lo
   Kind=loopback
   
   [Address]
   Address=192.168.50.100/32
   

3. Restart systemd-networkd: This applies the new configuration.

   sudo systemctl restart systemd-networkd

4. Verify the change: Check the IP address assigned to the loopback interface using ip addr show lo. You should see your newly configured static IP address listed alongside 127.0.0.1.

   ip addr show lo

Method 2: Using NetworkManager

NetworkManager is a common network management tool, especially on desktop Linux distributions.

1. Edit the loopback connection: Open NetworkManager’s settings (usually through your system tray or control panel). Find the ‘Loopback’ connection and edit it.
2. IPv4 Settings: Go to the IPv4 tab. Change the method from ‘Automatic (DHCP)’ to ‘Manual’.
3. Add a static IP address: Add your desired static IP address (e.g., 192.168.50.100) and subnet mask (e.g., /32). You may also need to add the netmask explicitly as 255.255.255.0 depending on your NetworkManager version.
4. Save the changes: Save the connection settings and disconnect then reconnect the ‘Loopback’ interface.
5. Verify the change: Use ip addr show lo to confirm that the loopback interface now has your static IP address in addition to 127.0.0.1.

   ip addr show lo

Important Considerations

• Subnet Mask: A /32 subnet mask means the IP address is only for that single interface and isn’t part of a larger network. This is typical for loopback interfaces.
• Conflicts: Ensure your chosen static IP doesn’t conflict with any other addresses on your networks.
• Multiple Addresses: Both methods allow you to have multiple IP addresses assigned to the loopback interface (e.g., 127.0.0.1 and 192.168.50.100).
• Testing: Use ping with your new static IP address to verify connectivity.

  ping 192.168.50.100